...can mess up the oil rings and compression rings resulting in the engine needing rebuilt out of my depth here with all these sensors ,but i would hazard a guess and say try changing the oxygen sensor
Question about Honda CRX
...injectors, MAP sensor, oil & filter, fuel pressure regulator) Have you checked the ignition timing? Maybe you need to turn the distributor to the left or right if you don't have the timing light ...
...sensor and if it idles really low rpms you should up the idle at the trottle body to idle at 800 rpms to be safe, To low of a idle will cause bearings to go out and throw a rod. Lookj at the valve ...
...Oil Pressure Sensor / Switch Replacement Removal & Installation 4.3L Engine To Remove: Oil pressure sensor removal/installation (4.3L engine shown) Clean the area near the oil pressure sensor. ...
...oil pressure sensor and the wiring to it. Oil Pressure Sensor Removal & Installation 3.4L & 3.5L Engine To Remove: Disconnect the battery ground cable. Raise and safely support the vehicle. ...
...OIL PRESSURE SENSOR OR SWITCH REPLACEMENT TOOLS REQUIRED J 41712 Oil Pressure Switch Socket REMOVAL PROCEDURE IMPORTANT: Clean the area around the sensor and Distributor before removal. Do not allow ...
...oil sensor needs to be replaced where is it the oil sensor needs to be replaced where is it located on the 8100 engine year is2001 Remove the engine sight shield. Disconnect the oil pressure sensor ...
...oil sensor on a 1997 dodge ram 1500 ...
oil pressure sensor electrical connector. Using J 41712 or equivalent, remove the oil pressure sensor. Fig. Using J 41712 or equivalent, remove the oil pressure sensor To install: Apply sealant to the
...oil level sensor was replaced, or do you mean the oil pressure sending unit was replaced? If it was the oil pressure sensor was replaced, then I would look into an oil pump going bad, not supplying ...
129 questions posted
Usually answered in minutes!