1990 honda crx my car was running i changed the fuel filter when i tried to turn the car on the starter would not get power engine not turning a have you checked the ground?
...not turn over. tested battery, found it was not working and will not charge. new battery install, honda will not turn over as if no electrical power. Not sure were to start, I have no diagrams of ...
...turn the shaft to the #1 position and go a little past the #1 position in the opposite way that the shaft turned.install the distributor and see where the rotor sits then.if it is still not in the ...
...not car started perfect before recently replaced the alternator and battery could it be the fuel pump also the oil light is on when trying to turn on car HONDA AND ACURA HAD ISSUES WITH THE IGNITION ...
...not do one more turn and check (they call top death center) -Now remove the rotor cap and line up the point to cylinder #1 plug wire on the cap, tight everything down and put the cap cover back on. ...
...not heard, turn key off and locate and replace the relay with one of the other window relays. Check window again. If it works now, get a new relay. More often than not, removing the motor and turning ...
...turn the cam so the rotor points to No.1. Then yiou should see some marks either lining up or close to it. If you have had the distributor out, set the cam and then worry about the distributor. Some ...
...turn signals, headlights, usually some other stuff too. you should make sure you don't have a blown fuse in your turn signal circuit too. not sure i know what the ignition buss is. hope this ...
...from front driverside wheel. This is not evident when a left turn is performed. Also more thread wear on the driverside wheel. Any ideas or solutions? Bearings or CV joints? most likely your
turn the headlights off, everything goes back to normal. Also my car will not start if it sits for more than 3 hours. Im always having the disconnect the battery when I go to work. Any answers??? Your
129 questions posted
Usually answered in minutes!