...hot enough to cause a serious burn. 1. Disconnect the negative (-) battery cable. 2. Loosen the belt tension by turning the drive belt tensioner clockwise. 3. Remove the drive belt. 4. Disconnect the ...
...clips... and make you a set of mini jumper cables... with me so far? now... take the wire set you just made... connect one to red... and one to black on battery... remembering to keep the wires ...
...clips. Install the air cleaner housing support bracket. Tighten the bolts to 25 Nm (18 lb-ft). Connect the air cleaner housing to the air cleaner inlet tube and the outlet tube to the throttle body. ...
clips,not holding the pressure of the hot water system.if you cannot do it yourself anyone with 1/2 mechanical nonce can replace one hose at a time until the leak stops........please use genuine parts
...clips to help that stay put and and unplug the connector that pluigs into the fan housing from under the hood. (it is nearest to the computer metal box and just above the battery. It unplugs and had ...
...hot pressurized coolant. Place a drain pan under the radiator drain. Open the radiator drain plug and allow the coolant to drain. Remove the air intake resonator from the air cleaner assembly. Remove ...
...clips and then also pry through the hole at the connection point. Picture below. Once you pry it will release. You will have to jiggle this loose but it will eventually come off. with mine the recirc ...
...hot coolant. In addition, when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in ...
...18) Remove the Thermostat (upper hose return) housing. Scrape off old gasket. Replace with 160deg or 190deg thermostat. Use silicone on gasket. 19) Carefully use a 17 or 19mm box wrench to remove the ...
328 questions posted
Usually answered in minutes!
495 Questions
353 Questions
191 Questions
166 Questions
75 Questions