...reset the check engine light on my Volvo S90? That code is for the engine coolant temperature sensor. You need to have a look at the connection to it, if it's good, replace the sensor. This is an ...
...front wheel and tire assemblies. Lower the vehicle. Install the left transaxle mount. Install the upper transaxle to engine bolts and stud. Tighten all of the bolts and stud to 55 ft. lbs. (75 Nm). ...
...front back the first thing the pipe comes to should be the cat it looks like a muffler with a wire going to a sensor after toward the back side of it, I doubt they never installed one but I guess it ...
Question about Pontiac Cars & Trucks
...Front Suspension. Remove the left stabilizer . Refer to Fastener Tightening Specifications in Suspension. Reposition and secure the drive axle toward the rear of the vehicle. Remove the trans mount ...
Question about Nissan Cars & Trucks
...Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor. p0154 = O2 Sensor Circuit No Activity Detected Sensor 1 Bank 2 Faulty Front Heated ...
...Reset. Yesterday was down to 1/4 tank gas, put in bottle of Lucas Complete Fuel System Cleaner and small bottle of Lucas Fuel Conditioner w/ Stabilizer per Saturn Of Cary Mechanic recommendation. On ...
reset codes and check eng. light came back on. More often than not the Cat is bad. Replacing the sensors is the easiest move. Reasons for the cat to go bad will be related to something else wrong with
Question about Volvo S90
...reset and see if the light comes back on. If so you need to have a scan done to see what is causing this code to set that code is for the heater and that alone. B1S2. this means the wires are cut, to ...
Question about Buick Cars & Trucks
...front or the right rear frame bolts. Refer to Frame Replacement in Frame and Underbody. Remove the left ball joint from the steering knuckle. Position the drain pan under the transaxle. Remove the ...
...front of some V8 engines, is a variable reluctance sensor triggered by a trigger pulse wheel (36 minus 1 tooth). Its purpose is to provide the PCM with an accurate ignition timing reference (when the ...
197 questions posted
Usually answered in minutes!
664 Questions
682 Questions
587 Questions
551 Questions
468 Questions