1996 Volvo 850 "makes starter coil heat" Questions

...heat can damage the old starter coils and make the core charge worthless. Use an impact driver instead. I agree with Brad about using an impact driver instead. If you really have to use heat, be very ...

.....that causes the igition coil to heat up.. but sometime age coil can be promblem to. try replacing by pass the starter motor see the diagrams attached, and chart for troubleshooting. God bless ...

I have a 2001 Chrysler 300m it got hot turns off got it on for like two sec and now can't get it to crank over I'm not getting power to my coils injectors fuel pump and starter watt can cause ...

...starter relay coil. The PCM then grounds the control circuit of the starter relay. When the starter relay is energized it allows battery positive voltage to the starter solenoid S terminal. On some ...

starter is bad. Also, if you have any questions about the procedure below, please let me know. Thanks for using FixYa. Removal & Installation Disconnect the Negative battery cable Relieve the fuel

starter, gell 860cca battery, new coil, new distributer, new plugs and wires, new fuel pump and filter, and the timing was re-set to OE. Gets spark, air, and fuel. All components are OE. to verify the

...starter turns over. Checked all under hood - fusable links, relays, grounds, all OK. Under the dash fuses all OK, all hot when appropriate. Any idea where to go from here? Thanks, for any tips Alfie ...

...starter. Also, on the HEI ignition(coil in distributor cap), you can run a wire from the battery to a rocker or toggle switch and then to the end terminal on the coil. Big wire on alternator goes to ...

...starter is CRANKSHAFT POSITION SENSOR. Disconnect sensor connector right below ignition coil assemble from top of engine. Slide sensor connector out of U-shaped bracket. Loosen 10mm bolt securing ...

...coil adn starter and i cannot get it to start -the last time ti tried- the starter got hot but still no start when i turned the key. i need to verify the coil and starter wiring i assume these are ...