1990 Volvo 740 "starter gl" Questions

...gl. Put new starter in, now it 1989 volvo 740 gl. Car was not turning over at all. I traced the problem back to the starter. I just put new starter in, now it sounds as if it is not disengaging after ...

...gl with automatic transmisson. My problem is that it wont start. It is not the starter motor because the electricity doesnt come that far. It stops even before it gets to the Fuel Pump Relay. When I ...

...starter on my 1990 volvo 740 gl. where is it located and how do i replace it? As you are facing the car, it is on your right hand side - low on the engine - toward the rear of the car. To remove, 1) ...

GL. If you have electrical starting problems whre do you begin and end with troubleshooting. I have cleaned all the connections on bat terminal, changed out the 2 black 40 amp relays. Changed the coil

...gl sedan and it sounds like the timings off could it be the flex plate oh and what is a flex plate a flex plate is the plate that is bolted one the back of the engine that the torque convertor bolts ...

gl CAR WON'T START -----HELP Had the water pump replaced - it was running fine before the repair, but was leaking a little radiator fluid out of the water pump. After the repair was made, it would not

GL wagon. Clicks when key is turned. Has new starter wires replaced as taken off. Can roll start, is manual, and runs fine. Any ideas? It def sounds like a starter prob, if you have replaced the wires

...gl will start sometimes but on rare occassions will not even turn over, no noise, just will not crank. I was told there was a "blind spot" in the starter. When the starter was st car has an automatic ...

...starter on a 1985 subaru wagon gl? This is done from the top /under hood...remove spare tire which will expose the starter motor. Remove both mounting bolts(17mm) and the electrical connector and ...

88 Subaru GL has power but will not turn over. new starter did nothing Are you getting power to the starter from the key switch thru the neutral safety switch ? Can you turn the crank shaft by hand ?