...the oil change the light is still on. How do you turn it off? 2008 montaineer. is this the oil pressure light or the oil change due light (u don't say), let me know so I can give u the correct
...change engine oil light is still on how do i turn it off? Use Reset button on Right of Steering wheel: To reset CHANGE OIL SOON/OIL CHANGE REQUIRED message on the Message Center, press the SET UP ...
...oil change on 09/06/2010 It is possible that when you had an oilchange the oil used was 10/40 which is correct for this vehicle BUT i would advocate that a thicker oil is used for this mileage say ...
...change your oil. The light is controlled by the ECM (Computer) in your vehicle. It monitors various sensors in your engine and compares them to variables or programs that is in its memory. When ...
Question about Mercury Mountaineer
turn the key like your going to start it to drain some left over energy out ofter un hooking battery then hook it back up see if this will reset the security problem.Have a shop or local advanced auto
Question about Mercury Mountaineer
change oil soon light takes time to turn off when i turn the car on the change engine oil light takes time to turn off even the oil is still new faulty check valve in the oil filter replace oil filter
...change light in a 2003 olds alero turn key on (dont start engine) floor gas pedal 3 times 1,2,3. turn key off, now start engine it should go off, if not try it again. Should be listed in your ...
Question about Mercury Mountaineer
...change oil light. Put the key in the ignition and turn it to the 'Run' position, but do NOT start the engine. With the key in this position, slowly push the gas pedal all the way to the floor three ...
Question about Mercury Mountaineer
...turn off the change oil light after the oil is changed? You don't need to do anything to turn off the light, it's not a change-oil light, but low-oil level light. Check whether the oil level is ...
...turn off warning lights on dashboard Change oil light and trac off lights, Change oil light: remove the driver side fuse cover, there is a reset switch. turn key to on position (engine NOT running), ...
1,036 questions posted
Usually answered in minutes!
555 Questions
524 Questions
377 Questions
323 Questions
250 Questions