2004 Jeep Liberty "4 throttle position sensor" Questions

...4-5 months. Seems to go off after I re-seat the gas cap (bought new one too), but comes back on a few weeks later.....stays on for a week or 2 then goes off. I got the code from a Scan Gauge device ...

4 TPS sensors. and 1 throttle motor and SOFTWARE if the 4 TPS (1 on right foot and in in TB throttle body) do not agree most cars go to limphome, and cruise is desabled. that is how TBW works. the PCM

...4 times in the past few weeks. P1299 Vacuum Leak Found (IAC Fully Seated) P0122 Code - Throttle Position Sensor/Switch A Circuit Low Input Not sure if you have solved this or not yet but these are ...

throttle body sensors. Remove 6 ignition coils. Remove 4 fuel rail mounting bolts. Gently rock and pull left side of fuel rail until fuel injectors just start to clear machined holes in cylinder head.

...throttle out, and had the fuel pump buellitin done. the place that i took it too said that i have good fuel pressure now. has anyone had this problem, or might have any ideas what might be wrong with ...

...4 and 5 ) Fig. 2: Disconnect the wire harness from the throttle position sensor-Legacy Fig. 3: Paint a matchmark on the sensor and throttle body for ease of installation and adjustment Fig. 4: Remove ...

4- P0220 Possible causes - Throttle Position Sensor (TPS) harness is open or shorted - Throttle Position Sensor (TPS) circuit poor electrical connection - Faulty Throttle Position Sensor (TPS) - Fault

4-cylinder Replaced the one on the throttle body, but still have trouble with the idle. Was told to replace the one on the throttle petal! There is no sensor on the petal!! Need location of the second

...3 wire connector..small black sensor..with a vacuum hose leading to it..throttle position sensor on right side of throttle body unit..3 wire sensor..iac located on front of throttle body..4 wire ...

...throttle body. 4 Unplug the electrical connector from the throttle position sensor. 5 Unscrew the two retaining bolts from the position sensor using a Phillips screwdriver and remove the sensor fro m ...