...cut so i replaced them and it still didnt work. i thought they might have been crossed so i swapped them and my 4wd light came on but the shifter was in 2 and all four wheels were engaged. i had to ...
...transfer case into 4wd either the switch or the vacuum motor are bad, the one on the transfer case has 3 vacuum lines connecting to it..make sure the lies are good (no cracking,cuts,etc...)..the vac ...
Question about Jeep Wrangler
...cut off end of a vacuum line halfway to the rear above the Rear wheel transfer case and I suspect it goes to the charcoal canister. Should be on the driver side near the rear axle. Its usually right ...
...transfer case were gone. Even the one that goes to the actuator under the battery box. Does anyone know where the vacuum lines from the switch to the engine go. Any help would be greatful. Thank you. ...
...transfer case is bad, or the vacuum line to the switch isn't hooked up. If you do have vacuum there, then put it back in 2 wheel and put the line back on the actuator and put it back in 4 wheel. Just ...
...transfer case, while someone turns the switch to 4H and 4L with a dead blow hammer ( not a metal hammer ). Some times the shift motor will get hung up and not shift. This will cause the truck not to ...
...line coming up from the transfer case,"it has been cut.Can you please tell me where it hooks up too.also the cruse control light comes on but it isnt working and i cant tell it the 4wd is kicking
...transfer case after all that the 4x4 High worked. then next day after warming up, didn't. ok well its hard to do without seeing it. but here goes. if it has electronic dash then it sounds like you ...
481 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions
