1990 Jeep Wrangler "install spider gears" Questions

Ad

Question about Jeep Wrangler

1 Answer

...spider gear shaft in place, removing the shaft and pushing in on the axle to remove the "c" retainer on the axle end. You can remove the bearing by prying it out using the end of the axle or by using ...

Ad

...Spider gears in a 1999 TJ with a Dana 35. Jack up the vehicle and place jack stands under the reared. Remove tires and brake hubs. Then loosen bolts on diff cover and drain diff grease. Remove the ...

Ad

install rear spider gears removed right rear drive axle to replace studs spider gears fell out having trouble installing gears back into place gears jam into inner housing not enough clearance removed

Question about Cars & Trucks

1 Answer

...spider gears with the side gears & rotate them into place. If the crosspin hole won't line up, rotate one axle shaft until it does. Install the new crosspin and bolt it in. Replace the cover ...

lost rear end but truck works in 4 wheel drive could it be the spider gears Could be spider gears or it's always possible pinion was installed incorrectly and now that's gone.

...install Detroit Locker TrueTrac to replace spider gears. Good luck. sorry nissan don't rebuilt part like that in fact if you go to the dealer and recuest for kits to rebuilt trans those guy will said ...

Question about Jeep Wrangler

1 Answer

...spider gears and shims back in and must be installed in the proper place.then push the axle into the differential and you may the C clip fall if not remove the C clip to unlock the axle and pull the ...

install. Don't turn the gears while toe cross shaft is out or the spider gears will exit to the floor. You can put your finger into one hole and gently turn it to avoid that, but don't jam your finger

spider gears. If your tire is already removed and brake drum is off, push in the axle and remove the circle clip. Once this is out you can slide your axle out you can remove the backing plate for your

...the bearing, then remove the seal. Reverse process to install. Be careful if turning the gear set after the pin has been removed. If you turn it and don't pay attention, the spider gears can fall

Not finding what you are looking for?
1990 Jeep Wrangler Logo

480 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...