head bolt removed from the head Fig. 10: Removing the cylinder head from the engine block Remove the head bolts. Lift the head off the engine and place it on a clean workbench. Remove the head gasket.
...head? if this has a plastic intake these have a problem with the intakes warping allowing coolant into the combustion chamber.the only fix is to replace the intake manifold and gaskets.make sure the ...
...head bolt threads with clean engine oil, then allow the oil to drain off before installing. On 1988-89 engines, install and tighten the cylinder head bolts, in sequence, as follows: Step 1 - Tighten ...
Head Bolt (4 Req'd Each Side) 4 6049 Cylinder Head 5 N802516-S Cylinder Head Bolt (4 Req'd Each Side) 6 6A008 Cylinder Head to Block Dowel NOTE: If original valve train components are being installed,
Question about Mazda Cars & Trucks
...head and camshaft,the cam dowel keeps snapping, the cam sprocket bolt tension is 45 ft pd torque but doesn't seem tight enough. 2001 B2600 Mazda Bravo, G6 Hi Wayne Wow this could have already caused ...
Question about Ford Cars & Trucks
head bolts are other complex topic, I never reuse any. do not over torque AnY VALVE COVER BOLT. M6 IS 60 INCH /LBS MAX. (NOT FOOT EVER) M6 WITH CORK GASKET COVERS, I IT , ARE WAY WAY LESS SO AS NOT TO
Question about Jeep Wrangler
...torque wrench, short ratchet extension and socket. 12 Rotate the three water pump assembly bolts clockwise an additional 95 degrees using the socket, short ratchet extension and a degree wheel. 13 ...
...torque to be applied. Once you get there replace the shoes if far gone brush all out, etc. and apply some grease to let pads travel. Bet is still the same. As first timer at least buy a manual with ...
bolt holes, and sensor mountings. The 1988-'92 engines did not use a cam position sensor, some of the 1993-'94 engines had cam sensors and some did not, while all of the 1995 and later engines had cam
480 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions