2002 Chrysler Town & Country "replace fan speed resistor control" Questions

speed control switch is in. The only way to turn the blower fan off is to pull the fuse or turn the ignition off. I had a similar problem about six months ago and resolved the problem by replacing the

a/c fan only works on high need to replace a/c speed control switch Have you tested/replaced fan motor resistor yet? Most common problem when fan only runs on high, is the resistor.

...shorts out causing full power to be sent to the fan at all times. If you are handy with a soldering iron you can buy this transistor online for about $5 and replace the one on the circuit

...fan runs. In other words, I cannot turn off the heat. I can adjust the temperature though. You have a bad blower motor resistor. It is located right behind your in-dash passenger-side glove box, and ...

...ideas? It is a 2001 Chrysler Town and Country. Have you replaced the blower motor resistor? It's located behind the passenger-side in-dash glove box. That's what allows you to control the fan

fan starts on high speed after a few seconds In my 2001 Town and Country without automatic temperature control, my heater/AC blower suddenly worked only when set on high. Usually, that problem is your

replace it in one session. I knew I had a bad resistor when my fan would only blow on one speed. If your fan won't blow at all, you still run the risk that the motor is bad and may need to pull it and

...has vacuum tubes and many wires connected to it.check vacuum lines for a leak,but the lack of fan speed control points to the auto module.Ford wanted $300,found one in a junk yard for $50.Good ...

...fan only works on high U WILL NEED TO REPLACE THE BLOWER MOTOR SPEED CONTROL RESISTOR, DO U HAVE AUTO AC CONTROL? HERE IS PART NUMBER FOR MANUAL AC WHICH IS THE MOST COMMON. STANDARD MOTOR PRODUCTS ...

...replace the fan speed controller/resistor. The blower motor is behind the glove box. BE SURE TO REMOVE THE NEGATIVE SIDE OF THE BATTERY FIRST(AIR BAG EQUIPED!). There will be the controller in the ...