2000 Honda Civic "replace glass drivers side window" Questions

...glass run channels on either side of the window. I have replaced the regulator twice and it is still having problems as I haven't replaced the run channels. If not replaced very soon I can see myself ...

the window channel.a friend told me I need to replace the regulator in the door. How can I remove the door panel to do this. a specialist of glass changing can fix the glass to route in its proper way

...it form the brace. tilt the front side of the window down and remove glass set aside, replace your new window and re assemble as you have taken apart, most cases this is about two hours, Good Luck

...side of the alignment tracks. in addition there are 2 screws holding the window to the brace that moves up and down. remove the window bolts first and remove the glass, then proceed with the rest of ...

glass set aside, now there are three screws for the regulator ( normally around the center of the door) and 4 crews or bolts , two on each window track, top and bottom) remove both bolts on each side.

...side window (not regulator) I bought a used 2000 Honda Civic, and I noticed that the window would roll (manual roller) half way down then get hard to move. Not only that, but it could get off center ...

...replace this? this is from a 97 civic should be the same. remove the door panel. remove 1 screw and pull handle, remove 1 screw and plastic cover over door opener handle. remove speaker cover and ...

...Replace any damaged clips. Make sure the connectors are plugged in properly, and the rod is connected properly. Make sure the window and power door locks operate properly. If applicable, install the ...

...REPLACE REGULATOR NOT SURE HOW Pull out window crank and door handle, remove panel, remove plastic Nylon that's between metal and panel, crank the window down enough to see the arm and the part that ...

...door panel and remove the glass that is left in the window track. Apply glue and place new glass in track and give it plenty of time to dry and set. Then replace inner door panel after all is