2000 Honda Accord "new alternator" Questions

New alternator and battery battery light stays on and car dies I thought the alternator was bad cause bat light came on. I tested the alternator by disconnecting hot lead on bat car died so I switched

...new alternator while tightening belt. You need about 1/8 inch slack on the belt. You can purchase a belt tension tool to help you measure. Tighten alternator bolts and plug wires. Turn on engine and ...

...new alternator (old one too, if you can return the new one) to an auto parts store. They usually do free alternator testing. If your old one is still good, you can put it back in, but check the ...

...new alternator usually read to fully charge the battery (12.3 - 12.8 volt range). Otherwise, the alternator will be damaged when it initializes. I have seen some extreme damage result from installing ...

...new alternator n battery both test out good but battery keeps going dead after a couple hours even after charging. checked ground on cable all good what could be causing this problem? your new ...

...new exhaust system. Since this problem began a few weeks ago, my alternator seems to have quit, but sometimes works again randomly as the battery light in the dash will go off, sometimes only when I ...

...new alternator, had both checked and both are good but will not charge.. check the cables that run from the battery If the alternator is putting out proper voltage and the battery is good, it should ...

...new battery and alternator. If there is a new battery and alternator it would most likely be your starter. If that isn't the cause then be sure to check your fuse box for and blown fuses. Autozone ...

...alternator was installed along with a new battery. When turning on the ignition no panel lights. Can it crank with a jump start? Check for good contact on the terminals. Also, some new batteries are ...

...new alternator mechanic checked it out but the alternator and battery is working fine at one point i checked the wires on the alternator and i read that the black and yellow wire should have power ...