1998 Honda CR-V "engine solenoid" Questions

solenoid p1259 code when started from cold the engine will stall out at 3000 rpm drop to idle and will continue this till the engine is warm and restarted . i was told it was the honda vtec solenoid i

...shift control solenoid and the lock up control solenoid. now the check engine light is on the on. the obd tester is reading a code po730. P0730 Incorrect Gear Ratio___________MST-3 diagnostic scan ...

engine suport+ bolts For transmission replace solenoide Replace 1 negative wire All above make any sense ? keeping in mind transmisions changed last summer. Thanks in advance for any input. it is very

...Solenoid Valve). Support the engine with a jack and wood block under the oil pan. Ground cable and upper bracket removal Remove the ground cable (1), and remove the upper bracket (2). Side engine ...

...solenoid? If you have a CEL (Check Engine Light) illuminated, and you are getting a "P1259" code, it refers to a "Vtec (Variable valve Timing and lift Electronic Control) System malfunction. The Vtec ...

...engine doesn't turn over. Have you had the battery tested or replaced ? Checked for loose cables ? The clicking is the solenoid on the starter That could be bad or the starter it's self That clicking ...

...above 1000 then higher as the high idle solenoid engages for air conditioning. If your A-C is on, your engine should increase idle. Try starting with no AC then turn it on after the engine warms

...engine light is on and D is blinking in drive? It means that there is a problem with the transmission, this is usually accompanied by a shifting issue and is usually caused by a bad transmission ...

...engine. If wiring is ok, then look at the starter solenoid for a good connection, and proper voltage at the starter. Problem is most likely the Solenoid's bendix gear or starting relay, Have someone ...

solenoid and starter terminals too and re-tighten. Then find the "ground" connections from the negative battery cable to the metal chassis and from the engine to the chassis, unbolt, clean, sand clean