Question about Cadillac Seville
...guess with out seeing the car in person, would be a cracked solder joint or a bad ground. This ( IPC) Instrument Panel Cluster has logic circuits and the ability to set codes. One of the first ...
Question about Cadillac Seville
...code present. The IPC receives a class 2 message requesting illumination from the PCM. Conditions for Setting the DTC P1574 A 2.5 mph or greater decrease in non-drive wheel speed in 0.4 second and ...
...Integration Module (RIM) via discrete inputs. The filtered fuel data is sent from the RIM to the IPC, via the class 2 serial data line. The RIM sends the IPC filtered fuel data on a change of 0.5 ...
...code mean? Using the Cadillac on-board diagnostic display you'll also see "IP" for the IPC instrument panel, "AC" for the air conditioning module, "TC" for traction control, "RS" for the road ...
...use the on. Board diagnostics too get the code if I remember right it is the off and warmer bottons press and hold then the ipc well run diag get the code but it is. More than likly a sturt is
Question about Cadillac Seville
...code read out and what it means. 8.8.8. ..E E13 E44 E52 E58 ..F F47 F48 ..F F47 .7.0 E13-Oxygen sensor voltage stays between 0.307 and 0.609 volts for 64 seconds. Engine was at normal operating ...
...IPC) . After the segment check, any trouble code stored in computer memory will be displayed.There is actually a LOT more to it than this, (like, what do you do once you have the code) but the ...
IPC) ?€¢ Instrument panel integration module (IPM) If it communicated with all the modules , then I would check for DTC's - diagnostic trouble codes ! If there was a code I would go to the diagnostics
...code from the IPC, it "assumes" that the IPC has been stolen and disables the engine to prevent the whole car from being stolen. If the IPC is replaced, the ECM has to be reprogrammed to accept the ...
Question about Cadillac Seville
IPC detects a loss of class 2 communications with the EBCM. sounds like you have an intermittent problem for now ! a wiring issue or wheel speed sensor going bad. Need to check for codes in abs module
355 questions posted
Usually answered in minutes!
234 Questions
173 Questions
175 Questions
176 Questions
149 Questions