...need to find the timing marks on both crank and cam pulleys, set it, then take of the belt ane dont let any pulley move! Put on new belt and set the tension of the belt. Need to know the engine
...cam UP print is up if you look closer to the gear it will have little mark just on the side of the thoot at every 90degre make shure the side mark of each gear alling with the top of the head (were ...
...cam timing slightly off your valves may be ok. The best advice I can think of is to re-time the engine following the correct sequence for the timing belt replacement and then perform a compression ...
...cam timing marks are. I see the crank mark on the plate behind the crank pulley. My sincere apologies for the delayed response. I have only been a free contributor to this site for the last 4-months. ...
Question about Acura Integra
REPLACE ENGINE. A FRIEND DID JOB AND OBVIOUSLY MESSED IT UP SO CAN'T TAKE IT BACK. PLEASE HELP ME FIGURE OUT WHAT COULD BE WRONG TO PREVENT DAMAGE TO ENGINE I'M HOPING? TIMING BELT AND OTHER BELTS ARE
...cam shaft and crankshaft positions aren't bound to each other via the timing belt, the valves can be pushed into the cylinder and rammed upward with no place to go. A Fiat head hanging on the wall of ...
Question about Acura Integra
...timing belt was most likely done "out of time". The cam must be exactly aligned with the position of the crankshaft during the timing belt installation. The tech that installed the new timing belt ...
...BELT DRIVE. CAM IF SLIPS AS THEY ALL DO AFTER 60 TO100K MILES COMPRESSION FALLS LIKE ROCK AND MISFIRES. SO IGNORING THIS BELT IS A HUGE HUGE PROBLEM. AND THIS HARD FACT All Honda engines are ...
...cam belt also drives the water pump and for this reason I recommend you replace the cam belt at 120,000 miles when you replace the cam belt the second time. Neither engine is an interference
...replace the belt. Make sure to recheck timing marks after new belt is installed by rotating the crank/cam back to timing marks, or just trust that the belt was replaced without the cam or crank ...
65 questions posted
Usually answered in minutes!
235 Questions
192 Questions
163 Questions
139 Questions
78 Questions