2003 Honda CR-V "remove install rear wheel" Questions

...remove the brake disc by hand. However, rust may have a firm grip on the disc. If this is the case, use a couple of 8-by-1.25 mm bolts and screw them evenly into the brake disc threaded holes. This ...

remove inner race from axle hub. To Install: Hub bearing assembly (Typical) Apply thin coat of grease to bearing contact surface and hub. Using and appropriate tool, press bearing into hub. CAUTION Do

...remove and discard the wheel bearing (brake disc shown). -Installation -All vehicles CAUTION: Support the wheel hub assembly on the wheel mounting face and not on the wheel nut studs. Using the ...

...Install the center cap. CAUTION: Never remove the axle shaft oil seal by itself. Always remove the rear wheel bearing and the axle shaft oil seal at the same time. NOTE: If the axle shaft oil seal is ...

Remove the drum with the inner wheel bearing from the spindle. To install: Install the drum on the spindle. Install the outer wheel bearing and washer. Tighten the locknut to 108-145 ft. lbs. (150-200

...Remove the U-washer. Reinstall the differential pinion shaft. Install the differential pinion shaft. Install the differential pinion shaft lock bolt finger-tight. CAUTION: Do not damage the wheel ...

...Install the tire and wheel assembly. For additional information, refer to Section 204-04 . Lower the vehicle. jack the car up and put it on safety stands, then remove the rear wheel of the bearing u ...

...remove it and install a new one. Install the inner wheel bearing oil seal using Axle Tube Seal Replacer T78P-1177-A. Use Premium Long-Life Grease XG-1-C or K (ESA-M1C75-B) or equivalent between the ...

...REMOVE STRUT ASSEMBLY.TO INSTALL ***** INSTALL STRUT INTO THE STRUT TOWER ALIGNING THE PAINT MARKS MADE DURING REMOVAL.INSTALL UPPER MOUNTING NUTS AND TIGHTEN TO 34 - 46 FT LBS. INSTALL STRUT TO ...

...Remove the brake shield from the control arm. Clean the control arm face and the bore before installing the hub and the bearing. Installation Procedure Notice: Refer to Fastener Notice in Service ...