Question about Cadillac Escalade
...engine to get it fired up. It drove for about 4 miles and now it wont start but the ignition will turn over. I changed the fuel pump and checked the pressure everything is good and still not working. ...
...4 times..it stop working. it would'nt turn over...i have tried to so[many lubricants and tried other house hold remedies but no success...please tell me how to solve this problem...before i have ...
...in the under hood fuse box. Put the temp in full cold. 3. Install the fuse. 4. Start the engine. DO NOT TOUCH THE HVAC CONTROLS FOR LESS THAN 45 SECONDS. 5. Have any codes cleared with a scan
Question about Cadillac Escalade
engine must be run for two and a half minutes with the air conditioner on and rear defroster on. The more electrical load you can apply the better. This will test the O2 heater, Passive Air, Purge "No
...engine is gona show as a lean code letting u know somenthing is wrong but it was created by a defective f/pump do not start dumping money in sensors because 1 sensor can go bad but not 4 at the same ...
...engine.Water started leaking when I filled resivoir.Why? Assuming that the leak was coming from the gasket that you just replaced, it could be due to several factors which include the following: 1) ...
...engine replace the fuel pump. it is located in the gas tank. ( FYI ) If you run below a 1/4 tank of fuel the fuel pump is no longer covered with gas, and over heats. thats why most of the gm pumps go ...
...4). After I installed everything and drove the truck for a little bit, I noticed that the engine started to missfire. I checked the wires and noticed that I installed them in incorrect order. So i ...
...4. what should i do? If the engine is running smooth clear codes and start again if the code come back start check in all vacum hose then check your ignition wires on 3and 4 fireing order Good luck ...
529 questions posted
Usually answered in minutes!
296 Questions
281 Questions
211 Questions
118 Questions
148 Questions