1996 Cadillac DeVille "4 thermostat housing" Questions

thermostat should be inside. On a 4.6L the thermostate is in the housing which is near the water pump drivebelts "on the coolant crossover housing". If this is not clean I recommend you buy the Haynes

thermostat should be inside. On a 4.6L the thermostate is in the housing which is near the water pump drivebelts "on the coolant crossover housing". If this is not clean I recommend you buy the Haynes

...4. Once the thermostat and gasket are in place, bolt the housing back to the block and put the hose (clamp) back in place. Add 1 gallon of 50/50 pre-diluted anti-freeze (or recommended amount per ...

...thermostat and the gasket. A little Permatex (just a thin bead smeared around the gasket) will add insurance against leaks. ***Don't forget to VOTE for the guys who take an interest in helping! Hi ...

4. Remove the thermostat and gasket from the block and clean the location good with a wire brush. This ensures a good seal for the new gasket. Sometimes it helps to have a razor blade or other scraper

...thermostat housing is located on top of the motor, underneath the air intake assembly. The easiest way to remove it, is just take off the air cleaner assembly. Unscrew the plastic nut on top of the ...

thermostat is behind it, note the position it comes out so you can install the new one the same way. Waterpump is in the same area, remove the 4 10mm bolts that hold the cover of the Waterpump housing

4. Remove the 2 screw holding the thermostatic compressor cycling switch and Carefully reposition it out of the way. 5. Remove the 16 screw from the cover and then remove the cover. 6.Remove the hoses

...Thermostat bypass hose from the coolant inlet housing Water pump cover 4. Remove the water pump by rotating it clockwise using special Tool J 38816-1A (water pump remover/installer). To install: 1. ...

thermostat housing is bolted to this cover. it has (4)10mm bolts that hold it on. 7. using the special tool, turn the water pump clockwise (it twist-locks into the housing) and remove it. 8. clean all