Question about Cars & Trucks
...single phase motor has to be connected to phase one and neutral. You're going to use more power that way. How long does it run before shutting off? Is the new pump getting hot? Have an electrician ...
Question about Cars & Trucks
...Single-phase 100 to 120 V, 3-phase 200 to 240 V, Single-phase 220 to 240 V. https://www.manualslib.com/manual/1087074/Juki-Ddl-8700-7.html#manual However, there STILL may be differences between the ...
Question about Cars & Trucks
...single phase motors that does not have a regulator resistor pack. 2 phase systems have a resistor pack resistor and 3 connections on the thermal switch, this is located in different places depending ...
...phase diode packs in the generator. 9) Verify charging: Measure the voltage of the battery with the cables connected. Voltage should be greater than 11.5 volts. 10) Start the engine. Measure the ...
Question about Buick Cars & Trucks
...single click I have a 2004 Buick lesabre I replaced the starter 2 times the second one has been tested everything looks good the battery is new and the alternator went out while I was driving so I ...
Question about Cars & Trucks
...single phase motor, the wire colors should be the same as the old motor. It is very important to connect the wires properly. But if it is a 3 phase motor, it does not matter how you connect the
331 questions posted
Usually answered in minutes!
267 Questions
254 Questions
223 Questions
198 Questions
182 Questions