1995 Cadillac DeVille "rear leveling arm" Questions

...need to locate load level relay rear height to low, pump do not come on , but manually works There is a switch with an arm on it that connects the body to the rear axle... likely it's not

where is the rear shock leveling sensor You have to pull rear wheels , look at frame an lower control arm . http://mastertechmag.com/pdf/2009/June/gmairsuspPDF.pdf

...rear control arm. If fuse is good, check for power at plug feeding compressor, compressor failure common. With suspesion at low position, sensor should send power to compressor. if no power suspect ...

...leveling systems wont go down Check the height sensor operation on the left rear wheel and see if the link from the sesnor to lower arm is connected. When sensor arm is pushed up the car will be ...

service ride control message is on Start by checking all level sensor one of the linkages could be broken. sensor are mounted on the control arms in the front and rear ( 4 total)

...arm. The rear end still only goes high enough to level of the vehicle. So what is my next step besides getting airbags or new shocks with the air inlet valve. you may want to buy regular heavy duty ...

...rear of the vehicle, the body rises, causing the sensor actuating arm to rotate downward. This again activates the internal timing circuit. After the initial fixed delay, the sensor provides a ground ...

...about 1 and 1/2 inches, and tightened in place. this will only work if your rear load leveling still works on the car, as the air shocks are pumped up resulting in a lift w/out fuckin up the whole ...

...rear tank electrical connector or at the fuel pump. Fuel Pump & Sender Connector - Description & Operation The fuel level sensor consists of a float, a wire float arm, and a ceramic resistor ...

...arm is connected to the rear axle and the level sensor, the arm itself should only be replaced if it was broken some how. This arm moves up and down with suspension travel and if you load the vehicle ...