...engine by and (remove spark plug it will be easier) a couple turn recheck if everyting line up and make shure the belt is still tight don't turn the engine with the starter because if you didn't ...
Question about Acura Integra
...engine. Step 2: Disconnect both battery cables with a socket wrench. Remove the four-prong connector and black wire located in the back of the alternator. Step 3: Remove the adjusting bolt and ...
...engine. That pulley has a 14 or 15 mm nut in the middle of the pulley. loosen it, but don't remove it. Behind the pulley on the bracket is a small bolt head. that will loosen the pulley shaft, ...
...engine oil change? omg are you serious? if you are not capable of doing an oil change i highly doubt you are able to remove the oil pan. best to let the mechanic change your oil, i don't want to give ...
...remove the upper bolts in the engine bay and the upper balljoint from the car but the bracket will stay hooked around the strut, There is a thinner metal on the backside of the upper control arm that ...
engine (left hand side) tucked in. One bolt to remove the earth wire (12mm) i think Two bolts (top and bottom of the starter) 14 or 16mm bolts undo those pull them out yank off the starter replacement
...remove the hose and clamp then install the new hose, and clamp , and tighten down, re fill cooling system, and then start up vehicle and check for leaks, add aditional coolant if needed, then install ...
Question about Acura Integra
...remove and replace the bypass hose on the cooling?heating system most cars this can be very hard. but you never said which engine options. the better question is how to get to it , no? on some cars ...
what should someone do if they replaced the timing belt on 1999 acura integera LS without first aligning the number one piston Now the the timing is inncorrect , are there bent valves what is the best
326 questions posted
Usually answered in minutes!
192 Questions
163 Questions
139 Questions
78 Questions
84 Questions