2002 Subaru Outback "having problems accelerating" Questions

my sub wagon 4 cl has transmission delay when I push on the gas when i push on the gas I get a delay in acceleration, the rpm go up to 5-6 then it accelerates. Some times it's up to a 2 second delay ...

can stationary steering damage a brand new car? I have asked this question a few times before Can steering while car is stationary in drive cause any sort of damage to a car. I was messing around with

I have a 2000 outback wagon. I am getting a noise I have a 2000 outback wagon. I am getting a noise that sounds like a gear hitting something. It goes faster wth car speed not engine rmp. It even does

engine light came on and car barely moved. The car has been running fine, no problems or hint of problem. I drove down to the store and when I came out to come home the engine light came on and car ...

My 2002 Subaru Outback starts fine but after a few minutes it seems to lose power and will stall. The plugs, wires and distributor were just replaced and the fuel filter was replaced prior. I tried to

spits and sputters(when it whants too) at acceleration when you step on the gas to take off or to increase power when under load If your vehicle is equipped with an EGR valve, locate it and pull off ...

Have a 2002 Outback that hesitates when it's upshifting, usually around 30-40 MPH. When accelerating to go faster at higher speeds, the Check Engine Light comes on. ( Resets by unhooking battery) The ...

2004, 6 cylinder outback, engine idle speed This engine, when cold idles at about 1500 rpm. This makes my car drive at about 30 mph without my foot on the accelerator. I have to go down a very rough ...

2010 outback accelerator sticking Have there been any problems with the accelerator sticking in the past. Today my husband was pulling into a parking space when the accelerator stuck and he ran into ...

high idle unless driving in gear, but if clutch is pushed in or car is in neutral rpm goes up to 2900 When you first start the car the idle goes right up to 2900+ rpm and stays there until you start ...