1988 Subaru GL-10 "timing marks" Questions

...timing marks. you have to turn the engine over clock wise untill you see them. There are 3 lines, line up the middle line with the pointer, put the left cam shaft sprocket mark straight down and the ...

...with carby no turbo.Which one is #1 cylinder, and what is the correct top dead centre angle for timing Number one is the forward most piston on the car, when the piston is at tdc, it will have a ...

...marks on the flywheel cover Driver side timing belt (No. 2) and No. 2 tensioner-1.8L engine Passenger side timing belt (No. 1) and No. 1 tensioner Disconnect the negative battery cable. Loosen the ...

...timing marks are there. If there are two green electric connectors on the drivers side near the firewall, connect those when timing. Make sure you disconnect after you are done. I assume you know how ...

...timing degree marks they are seperate from them, align them to the little arow on the houseing in front of the 3 little marks. be sure the e-brake is set, trany in nutral so engine can turn freely. ...

...timing marks and positioned the distributor to the right place. I have fuel, fire, and compression. I can't hear change in the engine when i turn the distributor when cranking. I'm at a loss on this ...

Sometimes the motor won't turn over; just a click when I turn the Sometimes when I try to crank my 1984 Volvo DL I only get a click and no engine start. My dash lights work, radio works, headlamps ...

timing marks on hyundai elantra 2009 4 cyl. valve timing, crank pulley T D C mark to mark on timing cover. Cam gear mark to mark on head or block . Ignition timing T D C mark on crank pulley to timing

...timing marks line up. There are three timing chains on these engines. On my Sorento even after the timing marks have been set and the engine is rotated by hand, after numerous revolutions the timing ...

...timing marks. Install right and left timing chain guides. Tighten bolts to 89 in-lbs (10 Nm). Rotate the left camshaft until the timing mark is at the 12 o'clock position. Rotate the right camshaft ...