...mirror gets dusty and needs cleaning. The mirror is located dead center in the front after removing the screen assembly. Its a small mirror directly in front of the lens assembly of the light
Question about Mitsubishi WD Televison & Video
have mitsubishi wd 65731. where can i buy lens assembly for it...? try to ask the service center they might help you and give you the right part for your tv not just a replacement.
...assembly from the Frame. MODEL: WD-52631 / WD-57731 / WD-65731 Screen Replacement CAUTION: Wear gloves when handling the Lenticular Screen and Fresnel Lens. This prevents cuts and finger prints. Do ...
Question about Mitsubishi WD Televison & Video
...lens until all the dust is removed.Next clean the lamp itself I used compressed air to blow the whole assembly clean and then wiped it down with a microfiber towel.Next blow out the tv one more time ...
Question about Mitsubishi WD Televison & Video
lens until all the dust is removed. Next clean the lamp itself I used compressed air to blow the whole assembly clean and then wiped it down with a microfiber towel. Next blow out the tv one more time
Question about Mitsubishi WD Televison & Video
...lens, the screen, and most likely, the mirror, but none can be discounted. All three can be accessed by removing the bezel and screen assembly. Most of the screws are around the edges from the back, ...
...pipe/tunnel" that is a is basically a mirrored glass conduit between the color wheel and the first lens. It is assembled with a high temp adhesive that holds the four glass sides together. The ...
...lens (the one immediately before the mirror) several times and it helps but the picture has gotten progressively darker. A new bulb didn't make a difference. Does anyone know if the light engine is ...
Question about Mitsubishi WD Televison & Video
...assembly. The large mirror is on the rear wall of the set. The small mirror is dead center in the front where the lens projects and then the small mirror reflects the image onto the larger
...lens assembly by removing the four torx screws. Keep Crt assembly vertical so you won't leak the fluid... Remove the inner lens by carefully prying up on the edge of it.Dump out the fluid in the sink ...
2 questions posted
Usually answered in minutes!
1,423 Questions
661 Questions
252 Questions
240 Questions
221 Questions