1999 Jeep Grand Cherokee "output shaft speed sensor" Questions

output shaft speed sensor or vehicle speed sensor and input shaft speed sensor which can be a computer generated signal from crankshaft sensor and output shaft speed sensor this is to determine torque

...the speed of the output shaft of the transmission not the driveshaft the sensor on the transfer case is for the speedometer and for the engine computer for fuel trim and fuel/timing curve Hope

output shaft is turning. This will tell you if this is a trans problem or a transfer case problem. If it is turning but the rear drive shaft isn't, inspect the transfer case. If the output shaft isn't

Which sensor is the output shaft speed sensor? that would be the one on the tailshaft of the transmission.

...output shaft speed sensor 1999 At the rear of the transmission, its usually light colored plastic with a two wire connector. Just remove the connector and the sensor unscrews. Be sure to check the ...

pin round plug for neutral safety and back up lamps just behind and above it a rectangular plug for the internal shift solenoids then on tail shaft is a 2 pin oval shape plug output shaft speed sensor

I have the output speed sensor. Where exactly on trans is that located please should be at the rear,near drive shaft. TIM...

shaft synchronizer, crank sensor, starter, throttle sensor. Before it would just shut off at random times. Consider a ground out (bad wire) to the coil pack? Or low fuel/no fuel pressure caused from a

...output shaft speed sensor and fixed a 97 GC V8 Ltd that would not shift out of low gear - this is externally mounted on/near the outside of the tail shaft. I replaced a throttle position sensor ...

...output shaft on the transmission. It has one plug on it. probably a 30 minute job. Please rate answer!! Thank you its not hard but that is about the right price to have it done right. But below are ...