1999 Jeep Grand Cherokee "change pinion bearing" Questions

Ad

Question about Jeep Grand Cherokee

1 Answer

...change one of the pinion bearings you really need to replace both since you will have the pinion shaft out anyway. At the same time you will need to replace the crush sleeve to set the proper load on ...

Ad

Question about Jeep Grand Cherokee

3 Answers

...change the following parts as follows axle shaft R/L, axle bearing and axle-u-joint.but still noisy Your carrier bearings and possibly the pinion bearings are the source if the noise is a low pitched ...

Ad

Pinion bearing noise will change pitch from acceleration to deceleration. Side bearing and axle bearing noise change pitch with road speed. Dana 35 series( oval cover) differentials tend to eat pinion

Question about Jeep Grand Cherokee

1 Answer

...pinion bearing.I would be prepared to replace all 6 bearings even if they appear good because of the age and they are prone to failure.Need to get the problem addressed before the ring and pinion ...

Question about Jeep Grand Cherokee

1 Answer

pinion shaft. It's a standard practice to inspect it [ if any damage is noted, then investigate further ] when replacing the seal and change the gear lube as it's usually contaimiated. Another

Question about Jeep Grand Cherokee

1 Answer

...pinion change the seal, make a dot mark with a punch on the nut and the pinion before removing the yoke to tight it at the same place, unless you do that you will burn the bearing it hapen to me one ...

Question about Jeep Grand Cherokee

1 Answer

...pinion bearing Could be the pinion gear ,,Has it been leaking rear end oil? How many miles on this?Probly over a 100k? its old enough for it to start wearing out.Try changeing the rear end oil use ...

Question about Jeep Grand Cherokee

1 Answer

...little louder when you hit a bump. It stops when you are not giving it gas..... most likely pinion gear or bearing in front differintial. not a cheap fix! if it was constant i would say wheel

Question about Jeep Grand Cherokee

2 Answers

pinion bearing is changed those settings need to be made again as well. Spider gears are easily replaced with no other work but you need to clear all debris from the insides to prevent bearing damage.

from the differential Either you need to change the grease in the rear and add a bottle of limited slip differential additive or the pinion bearing may be bad. Both are familiar problems on this model

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

3,837 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...