1997 Jeep Grand Cherokee "replace neutral safety switch" Questions

...Replace The circuit on newer cars with automatic transmissions has a neutral safety, or neutral start switch installed between the ignition switch and the starter. The ignition switch cannot operate ...

...put back through neutral a couple of times , it then selects 'Park'. Your neutral safety switch needs replacing.Here's the part. Duralast Neutral Safety Switch CR401 2004 Jeep Grand Cherokee 2WD

bypass neutral switch 4.7 engine automatic 2002 fix the problem with the neutral switch ( probably just adjustment or replacement) as it is a safety requirement to keep the vehicle roadworthy.

neutral safety switch, check it for power on both wires, if no power when key is on and in park or neutral then there is ya problem. also just try putting it in neutral and try starting it, if that is

Neutral Safety Switch". Check fuses of course. But if that is ok then try this. The neutral safety switch is located on the drivers side of the transmission case just above the trans pan. Pull off the

...so make sure you are replacing the correct ones. If you need to select neutral to start at a standstill, the neutral safety switch may also be bad, but that shouldn't turn it off after it's

...neutral safety switch to prevent starting if the vehicle is in drive. Some times when they fail, it won't start in park but it will start in neutral. Here is a good link to a site for learning about ...

...then it runs ok until i put it into reverse then it almost dies but it doesnt do it in drive Neutral safety switch just slam the shifter into park then try it again or start in Neutral, or replace

won't start in park will start in neutral position This is the neutral safety switch. You will need to replace it in order for your car to start properly again.

...neutral safety switch has this mode built into it,replace it,and take care of the problem. check reverse or back-up switch if jeep hasn,t changed these were really expensive at one time and if in ...