Question about Jeep Grand Cherokee
...washer. Or did you find that as well when you picked up the damper? Probably fell off a long time earlier. Buy a used one from salvage, or get one from a Jeep dealer. The damper should only go on one ...
...washer bottle wiring and hose. Remove fan shroud assembly. Remove A/C compressor and generator brace. Remove idler pulleys. Remove belt tensioner assembly. Remove upper and lower radiator hoses. ...
washer ,you could have caused a leak ,if there is no freon the low pressure switch wont let the compressor turn on,even if you didnt use high pressure,engine degreaser may remove corrosion on the line
Question about Jeep Grand Cherokee
...pulley on a 2003 Hyuandai Elantra? To remove the A/C belt from the car I removed the tensioner pulley. When I replaced the pulley and tightened the bolt that holds it in place, the pulley will not ...
...Remove bolt and washer from maintenance hole. Using a 6 X 100 mm bolt, scribe a mark 2.9 in (74 mm) from end. Insert bolt into maintenance hole and hole in balancer shaft. Install bolt up to scribed ...
...Remove bolt and washer from maintenance hole. Using a 6 X 100 mm bolt, scribe a mark 2.9 in (74 mm) from end. Insert bolt into maintenance hole and hole in balancer shaft. Install bolt up to scribed ...
...remove the nut, that the idler pulley should just slide off of the shaft. Well, mine lost some of the bearings and the inner thin washer was toast and the outer washer plate was bent up somewhat. The ...
Question about Cars & Trucks
...Pulley's are typically attached by a bolt through their centre. Replacing the idler consists of getting the bolt out and exchanging new for old. Here's the route I would recommend: SAFETY FIRST - ...
Remove key from crankshaft sprocket, Install: install key on crankshaft sprocket, slide pulley on, apply clean oil to bolt threads but NOT to washer contact surfaces, secure crankshaft w/ holding tool
Remove: Timing belt lower cover [7]. Crankshaft sprocket guide washer [9]. Timing belt. Tensioner pulley. Installation Installation 1. Check tensioner pulley for smooth operation. 2. Check free length
3,380 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,639 Questions