1997 Jeep Grand Cherokee "horn switch wiring" Questions

Ad

Question about Jeep Grand Cherokee

2 Answers

...verifies that the horn switch and wiring to the relay are working correctly. From there inspect wiring from relay to horn connection for damage / continuity. If that is good replace the horn

Ad

Question about Jeep Grand Cherokee

1 Answer

...switch is open, the horn honks. if the gray-org. wires is at 12vdc , then the relay is bad shorted, main contacts inside. if the wire is 0v, its wrong. ill stop, and wait until you find which it is, ...

Ad

The power feed to the horn does not depend on the ignition switch, so engine on or off should not make a difference. Try the horn when turning the steering wheel, the clockspring could be the problem

...switch to see if clutch would engage then and it did not. I then ran a wire from battery to compressor and it kicked in started blowing cold air was working great. I thought maybe I have a bad relay ...

Question about Jeep Grand Cherokee

1 Answer

...Horn "switch" is actualliy part of the signal mechanism and internal parts within the steering column...though these sometimes develop dead spots, it's least likely that it is the source of your ...

Question about Jeep Grand Cherokee

2 Answers

...switch on the steering wheel has a short in it. unplug just the horn until you can have some one or your self check out the wiring in the steering wheel and relays. this way you will be able to drive ...

...horn switch and relay. We thought that had fixed the problem. An hour after I left the mechanic with the car both the BRAKE and ABS lights on my dash went on and my speedometer stopped working (very ...

...horn deactvator switch on you key box switch, if you don't have that feature maybe your battery is weak on the alarm deactivator. you may have to pull the main alartm box and trace the main ignition ...

Question about Jeep Grand Cherokee

1 Answer

...in your steering column, specifically the part that connects your horn switch wires. The area where your steering wheel meets the steering column is a common place for electrical problems to

horn wire and removing the retaining nut and washer. Make a mark on the steering wheel spline and the wheel itself so you can line it back up precisely. Pull the steering wheel straight back to remove

Not finding what you are looking for?
1997 Jeep Grand Cherokee Logo

3,380 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...