1995 Jeep Grand Cherokee "cleaning abs sensors" Questions

...covered in brake dust and other metals. After cleaning these the light should go off on its own after a few hundred miles. If the light dose nt go off you can rent an ABS scanner at most parts

...How do you get the ABS light to go off. There is no computer reset. it wont go off unless you replace the bad part/s. Check your wheel sensors for broken wires and check and clean wheel sensor

...sensors reads 1.03 kohms. Reset the connectors on ABS control module, still ABS light always illuminated. Needs help. cheeck the e brake cable or brakes in the rear see if the brake in the back look ...

...sensors. Any ideas on why the ABS light is coming on with no stored codes? The only time there will be any codes stored in the ECM is when you get a check engine light. The sensors will sometimes ...

when braking the abs are kicking in even when I am just braking reg. YOU NEED TO LOOK AT ABS SENSOR AND PULL THEM OUT AT THE WHEELS AND CLEAN THEM THERE CHEST LIKE A MAGNET SO STUFF BILDS UP ON THEM ...

ABS light stays on Clean all the sensor tips with a mild sand paper.If that doesnt work you have a faulty sensor.

...the A B S light is still on. What have I done wrong??? Could it be you just had a cheap wheel ABS sensor bad or needed cleaning. Un plug and take an ohm reading they should all be the ...

1995 jeep grand cherokee brake problems i repalced the rear rotors and pads now im getting a pulse in brakes i push the pedel it seems stiff and pulses but if i pump them it seems to reset the abs and

...ABS brake light is on all the time -- even though they work fine. I have been told the sensors may be dirty--if so --how do I clean them? Hi Yes it might be the sensor on the rearend ... its located ...

...the toothed rings at the end of each of your axle shafts. The clockspring would have to be replaced, but the tone rings can often just be cleaned of rust so that the ABS sensors can read them