1995 Jeep Grand Cherokee "95 specs" Questions

what is the torque spec for the wheel lug nuts on a 2002 Jeep Grand Cherokee Overland with alloy wheels? 100 ft lbs, (+/- 15 ft lbs tolerance)...95 ft lbs is sufficient.

wheel lug nut torque foot pounds tighten lug nuts to what foot pound spec 85-115 is what the manual says. Most people do 95 to be on the safe side.

1995 jeep not charging battery dash lamp on,, tell you that or? bad battery (or cables to same.) bad wires. to alt. bad alt. belt fell off belt is not set to correct spec.tension. (illegal mods. or ...

...oil pump, i am still getting a knock from the #1 cylinder.the bearings show no abnormal wear.its a 95 4.0 w/ 110,000 miles and yes i primed the pump, any ideas? did you check the crank to make sure ...

...95, wont turn over, i have replaced the crank shaft position sensor, the alternator, distributor (the whole thing, cap rotor, and the whole distributer), i have replaced the starter, and batterey ...

I have a 95 grand Cherokee 4.0 the climate control and info center are not working at all, I have lights to the buttons but no display at all. I have checked all fuses everything is good. Whatis wrong

95 jeep grand cherokee. Alternator charges intermittently only after engine squeals, belt NOT loose. Upon start the alternator in my 95 jeep grand wont charge (6 cylinder), the voltage gauge stays ...

...lights are still blinking? what lights. do tell> we cant guess which of 30 lamps blink. the 95 , what engine, (size) and cylinder count./ we can not guess that either, cranks but no start,

95 grand cherokee with the 6 cyl.. My front drive shaft blew out on me way back when and i was running with no front shaft for a few months till i got the ujoints changed out. I just now put the shaft

95 grand am codes 34,27,55,19 Are you sure about your reading, Code 19 isn't listed. DTC OBD I Code 34 Description: Speed control solenoid(s) circuit is open or shorted Notes: For vehicles ...