Question about Jeep Grand Cherokee
...gauge for the oil hands going all the way to zero? Well the warning light is supposed to come on if any of the gauges display a dangerous condition, such as no oil pressure. You may have a faulty ...
Question about Jeep Grand Cherokee
...oil pressure. when stopping gauge goes to zero. today even going down the road gauge went to zero. If your oil is full, it's most likely electrical. If it's not electrical, then it's most likely ...
Question about Jeep Grand Cherokee
Oil pressure gauge drops to zero when car slows down, sometimes will go up when rpm reaches 2800, otherwise stays at zero, when shut off and turned on again pressure would be normal Lately gauge won't
Question about Jeep Grand Cherokee
...gauge? The oil pan is full. Oil pressure gauge reads zero pressure. The oil pan is full. checked wires on oil pressure gauge. ??? First you need to find the sending unit. Some are by the oil filter. ...
...your oil pump could be possibly going bad, I would do a oil change and use a high mileage oil and see if it fixes the problem, It is normal for the oil gauge to move but not good if it goes to
...oil pressure gauge drops to zero when i slow down Have a mechanical gauge hooked up to see that the oil pressure is good or not. If you have no or low at an idle, it can be due to bad oil pump, or ...
Question about Jeep Grand Cherokee
oil pressure gauge goes to zero and check engine light comes on but oil pressure is fine problem comes and goes If the oil pressure switch shows zero, how do you know its fine? If the oil level is ...
...oil filter and check the ground wire also 3rd - Check the gauge to make sure that the gauge is operating properly 4th - If all of the above chack out good---then it is your Oil Pump that needs to be ...
Question about Jeep Grand Cherokee
...oil gauge or fuse ? Is there a way I can check the oil pressure without relying on the gauge ? If it is a 4.0 strait six cylinder this is a common problem on them.Mine was located just below the oil ...
oil pressure gauge reads normal when first starts. as it warms up, gauge goes to zero. If I rev engine, gauge goes back to normal. Two things...when it reads zero, is there any engine noise (tapping ...
2,884 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions