2004 Audi A8 "hid lights turning" Questions

...Auto HID Xenon Light Did you try to turn the button to the right or

lights HID and they wont turn on. what could it be? also, before that. when i turn the HID lights off, it would flicker alot when its in the PARK LIGHT mode. right before you turn it off completely. i

...HID lights is that they require 12 volts or more to work. Daytime running lights on require 6-9 volts from the module. So when the original lights are replaced, the daytime running lights will not ...

...lights below but not yet HID, all 4 of theses systems has its own lamp but only high / Low are HID Retrofitting HIDs into halogen headlight assemblies is ******* and my look bright to you, but they ...

...hids, since they are not meant to run at say 4 volts like the factory non hid ones that are dim when the running lights are on.... I don't know if my answer will help you but I hope it does.. good ...

...hids, since they are not meant to run at say 4 volts like the factory non hid ones that are dim when the running lights are on.... I don't know if my answer will help you but I hope it does.. good ...

hid lights hi, i have a toyota camry 95 and i went to install some hid lights and the passenger side does not turn on and the driver side turns on,but it blinks.i checked the fuses and bulbs and they ...

...lights on my 2004 Subaru Outback LLBean so my newly installed HIDs work properly. HIDs flicker when in DRL mode due to lower voltage which affects the HID ballast performance. Where is the DRL module ...

lights because when the HID's 'light off' the use a lot of power until the bulbs warm up, then they actually consume less than a halogen bulb (usually 35 watts HID to 55 or more halogen). I have HID's

...HID lights use less amps. Duh. The circuit is showing a failure in the HID kit from not enough amps so it turns off. You need to add a resistor. To much amperage going to them you should never run ...