...big end bearings ,i think that the problem is internal ,,,firstly check oil level with engine running select reverse and make sure wheels are chocked up well first ,if oil level is well up then from ...
torque settings for Hyundai h100 new spec 2.5 big ends and mains There aren't no torque specs for a torque converter if it makes your feel better go 90 lbs
Question about Cars & Trucks
...big end bearings and flywheel torque settings. Also valve clearence for same engine. Flywheel for automatic transmission. go google and type in - torque settings for (your engine as you haven't given ...
Question about Audi A4
big ends,cylinder head,flex plate,flex plate to torque converter and cam shaft caps automatic You probably can get an owner's manual online to help you with those isssues for your fancy car. Good luck
Question about Opel Cars & Trucks
...big end bearing caps The settings should be in the manual . Rule of thumb for torque is 45 ft lb on the big ends and 65 for the mains. Sorry, don't know the metric specs, but you can check on the ...
...big end or main bearing both of which can be sorted by taking of the spark plug lead?coil and see it the noise fades somewhat.. Next is to take the tranny cover of and inspect the flexi plate before ...
Question about Nissan Cars & Trucks
...big end/main bearings dropped valve or insert broken rings bent conrod/s fuel/ water on top of a piston on compression stroke --remove the plugs pistons jammed in cylinders from overheat broken flexi ...
...big $$$).This code is usually the beginning of the end.If the vehicle has more than 80,000 miles and it was in my shop I would recomend overhaul due to cronic wear concerns with these ...
end up removing that cover to inspect the harness that goes to all the solenoids and then to inspect the valve body and the TCC solenoid itself. If you have a multimeter then you could ohm through the
big of cooler you have and if the lines, cooler, and torque converter are completely drained. Heres a tip before you start the car take the tranny lines off the tranny and take a 6'(it dont have to be
1,128 questions posted
Usually answered in minutes!
786 Questions
638 Questions
616 Questions
604 Questions
512 Questions