2005 Honda CR-V "fuse controls rear hatch door" Questions

...fuse? I have already replaced the batteries in the remote entry keys. Passenger door will not unlock with keyless entry, driver side has to unlock with key, and rear hatch will not open unless I ...

...rear hatch for the thump and you will find the actuator. Have you checked fuses for the radio? The radio fuse memory fuse might also control the seat. As for the door, it sounds like a rusted latch. ...

...fuse panel that controls the rear door locks and fuel door Lock. there are a whole bunch of relays in the REM that control different functions. Is possible that one relay is faulty and blowing the ...

...controls makes the rear hatch open or closes. I can survive with the hit because it is not that big but I need to make sure the hatch is properly closed. I need your help thanks. latch and lock are ...

...fuse (rear lock/unlock relay supply voltage) • ECC 10A fuse (liftgate lock relay supply voltage) If i were to guess i would say you mite need a new lock actuator , but i don't guess . You could take ...

...fuse box there is 2 relays, a lock relay and an unlock relay. The relays should be the same. If the door lock actuators work in the lock position but not the unlock position try swapping the relays ...

...rear hatch is locked permanently & will not open HELP my 06 tahoe just got this problem...all other doors lock and unlock with the fab and door switch...but the hatch is in permanent locked mode. ...

...over ride switch? I tryed to reset them according to the manuel. But it wont take. Try replacing the ECC fuse on the drivers side fuse panel. This seems to control quite a bit of the rear

...fuse that controls all of that? As far as the hatch and the wiper in the rear: 1 common problem is the wiring at the top at the hatch. Due to the poor wiring layout here, this flexes quite a bit with ...

...controls the inside locks, that doesn't work! The lock switch/ control at drivers door doesn't work and nor does the switch to open the back hatch! I have power to switches at drivers ...