2005 Honda Accord "remove inlet manifold" Questions

...remove the IAC from the side of the throttle body, careful with the gasket if you want to reuse it. Spray it down good inside moving the valve back and forth as you do let it soak for a few minutes ...

...inlet manifold. Connected to the underside of the EGR valve is a metal pipe connected to the exhaust manifold. Faulty EGRs are down to either encrusted carbon deposits holding it open or a broken ...

...Remove accessory drive belts.Disconnect the inlet hose from the power steering pump and plug the hose immediately to prevent fluid leakage. Remove the power steering pump from the cylinder head and ...

...inlet. Always use a new gasket anytime the throttle body is removed-1990-93 Accord shown (others are similar)- CLICK HERE FOR IMAGE ZOOM The throttle position sensor is mounted on the side of the ...

...Remove accessory drive belts. Disconnect the inlet hose from the power steering pump and plug the hose immediately to prevent fluid leakage. Remove the power steering pump from the cylinder head and ...

...Remove one screw and slacken the other to rotate the plate. Within you will see the conical metal valve end in the middle with a plastic annular surround with two notches in it. Using a stubby screw ...

...inlet manifold to the servo unit,stuck open and cause the engine have a vacuum leak . Or the servo unit itself stuck according to diaphragm move ability after the vacuum.If the brakes now are working ...

...manifold using new nuts. Install the timing belt. Install the valve cover. Install the cylinder sensor (if equipped) and the distributor. If applicable, install the alternator. Install the power ...

...power loss and your speed would have been down to - 40kph If that was the case then yes the cat has collapsed and needs replacing where is the bolt located under the vehicle to remove inlet ...

how to remove inlet manifold loosen the bolts situated around the inlet manifold and also remove the joint of gas pipe from the manifold.