...EJ 25 motor teeth count is as follows. From crank shaft mark to intake on drivers side is 51 T, 28 T to exhaust. From crank to passenger side Intake is 54.5 T then 28 T down to exhaust. Hope this ...
...Ej-25 motor has 4 cams. Cam sprockets are marked as follows. Intakes have single hatch mark which point straight up and a double hatch mark that face straight down at double hatch mark on exhaust ...
PINOUT DIAGRAM SUBARU EJ 25 WIRING DIAGRAM look up some of the online subaru forums one for example http://www.subaruoutback.org/forums/42-australia-new-zealand
...EJ-25 motor requires the removal of front covers, timing belt, and the timing gear for the cam that needs replaced. The seal can be replaced without removing the valve cover or cam. The installation ...
...EJ-25 motor it is a little involved but not a hard job. Do your self a favor and when removing the Timing belt make sure you put it at TDC and line the marks correctly so assembly will go much ...
Question about Daihatsu Cars & Trucks
...EJ is electronic injected.
the HC has cam timing belt and not one lasted 25 long years
5year/100km is life of belt
if belt is bad power stays low (HP) all the time engine shakes.
base on ...
...25 tries or not @ all until after work when the weather was warmer. Got into my car one morning @ pressed AUX button to play CD. Disc was ejected, but LOAD did not appear. Now when I press LD/EJ ...
Question about Subaru Forester
...ej 25 engine) Grandwagon have a flat spot when cold and sometimes when hot 1500 to 2500rpm intermittently occurs. so far I have replaced the fuel filter throttle position sensor, knock sensor and ...
Question about Subaru Forester
...and year? If it is the Ej 25 DOHC all the marks are on the cam sprockets except the crank is marked in the block almost straight up, Just a small notch. Good luck and hope this helps. Have a good
157 questions posted
Usually answered in minutes!
354 Questions
253 Questions
240 Questions
167 Questions
170 Questions