glow plug #3 control circuit low. Looks like a problem with your #3 glow plug,either the glow plug itself or the GP driver in the PCM. This would explain the starting good one time then hard the next.
wont start in morning Hi if the car is a diesel engine then you need to repalce the glow plugs these are used to heat up the diesel for starting the car from cold once the car has been run or if the ...
...glow plug rail, Its easy to do, get a thick electric cable and hold it on the positive side of the battery and then onto the Rail connecting the glow plugs, do this for 20-30 seconds and try to start ...
...glow plug controller. It is located between the battery and the brake fluid reservoir - attached to the battery tray by a x-mas tree type push pin. Easy to see if you look at that spot. There have ...
Question about Jeep Grand Cherokee
...glow heater plug in my Range Rover a jeep cherokee range rover is this a motor swap... ???? if really a full RR, please post to Rover. and get the FSM. be sure to get the FSM for your country,
Question about Jeep Grand Cherokee
glow plug, relay wiring K152 wt is connected somewhere at C102 where is it located? Jeep grand cherokee 2.7 diesel , glow plug control relay circuit Some fixya user told me a website reliable-store it
...deisel ok you need to still check fuses and relays but you can take a test light and check all the glow plugs and if it will run after a shot of either then the glow plugs are probbably bad and you ...
glow plug end stuck in cylinder head the bottom ends of the 2 of the glow plugs have broken of and is stuck inside - how do I get it out? If the piece with all the tread's on it has screwed out then a
...the morning for 1st start i need quick start on my 2.8 crd. any idea please? get a plug in block heater dont use starting fluid it can destroy the engine the glow plugs are probly not working ...
Question about Jeep Grand Cherokee
...not active, SKIS/SKIM.? so compression is at spec. and if it is ,test fuel diesel works????? Glow plugs work? (we measure current) then filters then pump scan pcm for errors, not all errors ...
2,181 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions