Question about Jeep Grand Cherokee
...1996 jeep grand cherokee lmtd. won't start did tune up. cranks but no fire. please help. engine code 54 shows up . cam shaft positioning no signal. . tested all circuit. changed cam shaft positioning ...
5 second and releasing the key on all cars. 1996 and newer a scan tool is use to same effects. now the 64,000 dollar qustion, see page 8w-30-4 why does the ASD KILL THE IGNITION coil. easy. 1: it only
...cam sensor, and coil.....i find now i have appro 5 voltsw of power going to the coil with the switch in run, when you put switch into start postion you lose all power....no fire into or off the coil ...
5 min after shutting off engine.. if pressure is with in parameters then check ASD relay in fuse block under the hood. you can swap it with the transmission relay to see if your jeep will stay running
1996 Jeep Grand Cherokee Laredo was not firing but now after replacing PCM and crankshaft and cam sensors and checked all fuses and relays it is getting correct amount voltage and will crank but while
Question about Jeep Grand Cherokee
...cam or spark timing errors. 4: bad fueling. (too much or too little) 5: stuck open EGR or stuck closed ISC. these 5 break out to 50 causes. we not bother or worry that. we do 5 tests and bingo the ...
...cam sensor is mounted in the distributor rotor area, under the cap. It is an integrated part of the distributor. 2. Spark plug(s)- replace if necessary. 3. PCV Valve - Check the valve, and hose for ...
...1996 Jeep Grand Cherokee Limited Jeep started up fine and ran fine this morning. No noticeable problems. Ran like a normal 16 year old car would. Then, after it sat in a parking lot for approximately ...
...cam sensor to pcm to send it in to auto shut down mode thers a relay for this called asd relay if you can get veh to stall and restart by the way ive mentoined then place your finger on the asd relay ...
2,181 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions