...2.8L, The check engine light is on and when it gets up to about 3000 rpms and higher its starts flashing, i just replaced the spark plug wires due to a mis fire. also it take longer than normal to ...
...2-3K RPM before or after it doesnt want to start. I know this car is fuel inj. but it seems to help if I press on the gas lightly when I turn the key after it hasnt started. After it hasnt started ...
...2 circuits in there: 1 for the brake lights and the other for the car computer (ESP, Engine brake etc...) If the brake switch has an intermittent fault, the EPS light may come on and the car may run ...
...2 different auto parts stores - starter drawing 200amps while spinning at battery terminal - getting 12V at solenoid terminal when ignition in the start position - all fuses ok - suspicious of ign ...
Question about Audi A6
...2 hours away and they charge $90 and hour. Help?? It absolutely could be the immobilizer (security system). Have you ever had the master key? All the keys should work but if one becomes deprogrammed ...
...2. Extract old brake pads wires from old brake pads. 3. Insulation wear cap from old brake pads wires. 4. Connect old brake pads wires on the vehicle electrical circuit. 5. Switch ignition ON and ...
...2. gearbox change problem, sometimes wont change gear. 3. engine racing (high revs) 4. new underbody-damage to front chassis and rear chassis. 5. misfiring when starts, hot or cold. The car is still ...
...engine coolant could no doubt do with a flush and change in any event as it should be done every 2 years. If you don't know when it was last done - do it. Cooling systems tend to be a neglected part ...
589 questions posted
Usually answered in minutes!
469 Questions
474 Questions
347 Questions
186 Questions
183 Questions