nut the while the vehicle is still on the ground take the hub cap off and the cater pin out and then put the socket on the nut using a halt inch tourge ratchet loosen and remove the nut then jack your
Question about Suzuki Grand Vitara
...Size (mm): 36mm. Torque https://www.google.com/search?q=2002+Chevy+Suburban+Z71.+axle+nut+torque .. no VIN or RPO list posted to learn true drive-train
RPO NP3= awd?
no job or problem told. ...
...size of the bolt on my drive axle hub nut that keeps the hub on the drive axle ? If it's still driveable, just remove the hub cap and go to autozone and have them check it out for you. they'll give ...
...size sockets ext the right foot lbs of torque for the axel nut, TOOLS YOU NEED IS 35 METRIC SOCKET FOR AXLE NUT.USE 6 POINT SOCKET.DONT USE 12 POINT SOCKET.COULD DAMAGE AXLE BOLT EDGES.MAKING IT HARD ...
...SIZE COULD BE 34 OR 35 METRIC 1/2 INCH SOCKET.YOU NEED 1/2 INCH BREAKER BAR.ONCE YOU LOOSEN AXLE NUT A LITTLE THEN RAISE VECHICLE THEN REMOVE WHEEL.THEN FINISHING REMOVING AXLE NUT AND WASHER.THEN ...
...hub assembley . Just find out what size the front half shaft nut/ lock nut/axle nut- is. its probably a 33mm thats the only special tool you will need. Unscrew it, take your outer tie rod off the ...
Question about Ford Cars & Trucks
...size socket required for a 2012 Ford Fusion Axle nut? Also, what is the Torque spec to secure it back on? Working with Front-Right wheel. The one that fits! That's not the way it works. you buy a ...
...size socket, remove the nut in center of hub. Some vehicles have a kotter pin in the shaft just in front of nut. If so, remove pin before nut. Next, you will need to loosen a few bolts that hold the ...
...the rotor. Remove the center axle nit. Remove the hub and bearing. Pry the axle out from the trans housing for a snap ring holds it in. It will pop right out if a screwdriver of a thick size is ...
...hub assembly remove the wheel, then remove the caliper and tie of to the side, slide rotor off, remove the axle nut, remove the lower balljiont nut, use a balljoint sperater tool to break balljoint ...
433 questions posted
Usually answered in minutes!
382 Questions
432 Questions
410 Questions
255 Questions
230 Questions