1996 Plymouth Neon "replace cam sensor" Questions

Ad

Question about Plymouth Neon

1 Answer

...sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends to crank and cam sensors sounds ike it could be the ...

Ad

...cam sensor and crank sensor, replace the wiring harness and check the cam shaft magnet! And i have checked the cam shaft sprocket pin to make sure it was not gone " just in case the cam timing ...

Ad

Question about Plymouth Neon

1 Answer

...position sensor intermittent 0340 cam position sensor failure I would replace the cam position sensor from the codes you provided. The knock sensor would most likely be related to the sensor

Question about Plymouth Neon

2 Answers

...cam sensor? you have a bad crankshaft sensor. replace the crank sensor. dodges and gm's are known for this problem. already replaced that whne i did the cam sensor idk if the braket bent wne i put it ...

Question about Plymouth Neon

1 Answer

...can the cam sensor cause these problems? the cam sensor definitly can cause the problem. pull the trouble code and make sure the check engine light is for the cam sensor. if so, replace it and ...

...cam sensor on my 2000 neon, check enfine light still comes on, my code reader still states it the cam sensor, could it be the wires into the sensor? If you are getting a cam sensor code, it is not ...

Question about Plymouth Neon

1 Answer

cam sensor 1995 neon, code 22, I replaced the cam sensor and it still shows up. Just did a head job and when I put it back together I might have cracked the magnet in the single OH cam where can I get

Question about Plymouth Neon

1 Answer

replace the cam sensor it should be in the same place. look on the right side of the motor you should see it. it'll have a small wire harness that clips in the top and its fastend with 4 bolts. Oh and

...cam sensor was replaced. Should anything else be checked/changed? Any problem with the cam shaft now? 2005 Dodge Neon. Also, all the door handles/latches stick. One has had to be replaced all ready. ...

i keep replacing the cam sensor and it fails after 24 hours I had the same problem and found it to be the coil (transformer ) powering the cam sensor and replaced it. Problem solved.

Not finding what you are looking for?
1996 Plymouth Neon Logo

174 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Plymouth Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...