1995 Plymouth Neon "engine coolant sensor 95 dodge" Questions

engine. How do I change the coolant temperature sensor in it please? Coolant Temperature Switch (Sensor) Replacement Service YourMechanic https://www.yourmechanic.com > ... > Grand Caravan On average,

...idle for a few minutes then it idles fine. The check engine light is not on either.... any advice? you may have a bad engine coolant temp sensor. that is what frequently causes that issue on ...

...Engine Running Too Cool 21 Problem In Oxygen Feedback Circuit 22 Coolant Temperature Sensor Circuit 23 Charge Temperature Sensor Circuit 24 Throttle Position Sensor Circuit 25 AIS Motor Drive Circuit ...

...engine to stop running if its **** in the rich Position. yes it can but you may have a coolant temp sensor acting up which causes the computer to open the injectors to much which can also cause this ...

...coolant temperature sensor, radiator not working or it is leaking, fans not kicking on, radiator fuses, faulty water pump. If your check engine light is on, best bet, take it to Autozone. They will ...

...engine is plenty hot. I assume you did top off the coolant, correct ?? and you still have this issue I have the 95. But their infamous for water pumps to function badly and or blades start to age and ...

...engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once ...

...coolant temp sensor,plugs and checked cap,rotor,ohmed the plug wires and also have my catalytic converter removed. it also does it intermittently at lower speeds but really noticeable on the highway ...

...engine most likey.Remove the coolant temp sensor located just next to the thermostat housing.Pour coolant in the radiator till no air comes out the hole and replace sensor and top off radiator.it ...

engine gets to normal temp or after the it goes to closed loop. Then while driving it will start to studder and finally loose all power and stall. If I let it sit for awhile it will start and run fine