Question about Mercury Villager
...the tension bar.? You don't lossen the nut holding the pulley on the tensioner,you pivot the tensioner arm to loosen the belt The should be a hole for your ratchet in the arm, to pull off the ...
...tensioner can be released and the belt removed then put new belt on all pullys but one at this point tensioner bust be realesed again ultill belt is plased on last pully be suer belt is inline with ...
Question about Mercury Villager
...belt,idler pully,tensioner for 2004 lexus ls 430, when start engine has a noise look like from pully After shop changed a timing belt, idler pully,water pump and tensioner, when start the car engine ...
...tensioner and put the belt over the altenator pully. Double check to make sure the belt is riding correctly on all the pullies before starting. Crank the engine over several times before starting to ...
belt broke, there's no sticker under the hood that tells you which bolt adjusts the tension first you need to figure out if you have an automatic tensioner or an adjustable one. so look at the pullies
...belt tensioner,pry back on tensioner(be carefull)and carefully place belt under roller pully of the tensioner,release and check allignment of belt prior to starting.oh ya make sure belt is in good ...
belt on look across pullys and maske sure the tensioner pully is aligned with the rest of the pullys remove the belt spin the pully by hand it shouldnt make any noise and it shuold feel smooth with no
...tensioner away from the belt. Remove belt. fit new belt to most pullys except the easiest to get to, lever the tenioner back & fit the belt to the last pully, Check the belt is on all pullys ...
...to be the last one the belt goes on. Move that tension pully as mentioned above and place it the belt on the pully. The diagram under the hood should also show you where that tension pully is
235 questions posted
Usually answered in minutes!
478 Questions
379 Questions
326 Questions
276 Questions
247 Questions