1994 Mercury Villager "adjusting distributor timing" Questions

...timing on the crankshaft pulleys because the paint has worn off. I looked at a new crankshaft pulley and the yellow mark was on the far left end, so I timed the engine at 15 BTDC (3 notches to the ...

...adjusting the basic ignition timing, recheck the idle rpm and secure the distributor. Recheck the timing once again to verify that the timing is correct. Remove the jumper wire, reconnect the vacuum ...

...distributor cap is to set dwell, not timing. You can set dwell by removing the distributor cap and gapping the points to specification, then verifying with a dwell meter. If dwell is off, remove the ...

...distributor may need adjusting to prevent crossfire. To insure proper alignment of the distributor, perform the following: 1. With the ignition OFF, connect the scan tool. 2. Start the engine. Allow ...

...one tooth off when you try to adjust the distributor's position. If you cannot adjust the position to set the timing to the Toyota spec, pull the distributor out and adjust the shaft position 1

...AND TIMING IS ADVANCED TO MUCH loosen distributor adjustment screw under distributor. with engine running turn distributor until engine runs smooth. better yet, use timing light during the

...DIS, how do I set the timing, and where do I adjust what ? Does the car have a distributor ? or you say DIS distributor less ignition ? If no distributor you can't adjust timing ,computer does it

...DISTRIBUTOR AFTER A TIMING DRIVE BELT BREAK ON A 98 JEEP WRANGLER 4.0 timing drive belt? there is no timing belt, and the drive belt does not affect timing ,so what is the question? the distributor ...

...timing chain or the distributor shaft. Here is what the service manual states about ignition timing: "NOTE : The Distributor is located in a fixed, non-adjustable position. No attempt should be made ...

...distributor may need adjusting to prevent crossfire. To insure proper alignment of the distributor, perform the following: With the ignition OFF, install a scan tool to the DLC. Start the engine and ...