1993 Mercury Cougar "gear cables" Questions

cables look fine.Shifter lever on trans.seems like it doesn't fully move when I move the shifter.Pulled into a parking space fine and went to leave,put into reverse and backed out.Then went to

...cables onto the terminals and tighten the retaining nuts to 80-124 inch lbs. (5-7 Nm). Install the air cleaner support bracket. If removed, install the gear shift selector and bracket. Install the ...

...cables onto the terminals and tighten the retaining nuts to 80?124 inch lbs. (5?7 Nm). Install the air cleaner support bracket. If removed, install the gear shift selector and bracket. Install the ...

...rate if this helps If your 95 XR7 odometer stopped working the most common problem is the plastic gears. They get so hot the surface shows bubbles that weaken the gears and eventually cause the

no reverse after new clutch and linkage cables no reverse after istalling new clutch and cables, is this a alinement problem? No, it has to be that the gear is shaved and needs replaced.

I have a Ford Aode transmission in a a 1990 Mercury Cougar xr7 I think there is a problem with the linkage or cable because at first the gears all worked then we adjusted it and it only goes forward ...

where is the motor located on a 2000 couger for the sunroof The sunroof drive motors are usually in the trunk area , they are robust and sometimes bulky as large effort is required to operate the ...

...and cant afford to put in in the shop for diagnostics. if this is a manual car with an mtx 75 gear shifter is stuck more than likely the cable linkages broke. i believe you have the 2 end

car will not shift into gear started car,shifted into reverse & backed up 5 feet,shifted into drive - nothing! back to reverse - nothing - no click into gear. totally immobile.locked in ...

hard to shift into first gear The car just became hard to shift into first gear. After about six miles of in-town traffic, I noticed the gear shift is now getting harder to shift into 2nd gear, too. ...