1987 Chrysler Fifth Avenue "jeep carburetor adjustments" Questions

Ad

Can you adjust the float valve from the outside of the carburetor on a 85 jeep Cherokee 2.5l engine? No and in fact you cannot get parts or replacement carbs for that vehicle that are OEM

Ad

...carburetor on a jeep cj5 1977? 1977 now that is a blast from the past. finding books that old is hard, but are sold in book stores. but from Carter, and very very old jeep books. 4 engine then and 2 ...

Ad

Question about Chrysler Fifth Avenue

1 Answer

jeep comanche (2.5L) hesitates when taking off. It acts like it is not getting enough fuel. I have changed the fuel filter and there was no change. The fuel appears to be spraying in a consistant cone

jeep wrangler high idle speed, replaced pvc valve and grommet . can I adjust it or is it computer controlled? replaced cat and o2 sensor, only code that pop up is a power steering switch failure, even

Question about Chrysler Fifth Avenue

1 Answer

motor getting too much fuel Check that the carburetor if so equipped, has its idle screw adjusted right for minimal emissions. If it has fuel injection, then the injector(s) may be leaking. Check for ...

Question about Chrysler Fifth Avenue

1 Answer

...jeep has not been modified it is likely the Carter BBD Carburetor on that engine, or the sensor inputs to the carburetor. The Carter BBD has an idling circuit that is always seeking. There is a ...

Question about Chrysler Fifth Avenue

1 Answer

will not idle properly its running in a 86 Cherokee with the jeeps two barrel carb on it There are many possible solutions including: Bad gas, needs tune up (points, plugs and/or timing), idle ...

...Jeep had been stored for 5 years. Fuel tank and fuel pump has been replaced. Any ideas? With the engine off, Look down into the carburetor and move the throttle. If you don't see a healthy squirt of ...

Question about Chrysler Fifth Avenue

2 Answers

choke seems to be on... runs very rough.... There are several ways to do it a. Check carburetor if not clean pump it on the intake if that not solve try to clean it. with Lacquer thinner to dissolve ...

Question about Chrysler Fifth Avenue

1 Answer

...jeep wranglers float in the carberater? Carburetor floats are adjusted (if needed) when the unit is rebuilt. This is not a normal maintenance item and it is unusual for a float to become misadjusted. ...

Not finding what you are looking for?
Cars & Trucks Logo

150 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...