size of your small finger, remove these and replace with ball bearings. Pack with plenty of wheel bearing grease, now comes the difficult part. Using a punch punch out the rivits holding in the window
...size and shape. The pressure plate comes off by itself when you remove the tranny, because it floats on the shaft next to the splines, which will have to be replaced also (in the clutch kit). The ...
...that is what you asking about) are not a bearing adjustment, you can go with a generic torque based on bolt size. Again, I'm not sure what component, or bolts it is you are asking for torque specs
Question about Chrysler Sebring
...bolts holding it all to gether not the axle nut on the front hub assembly on my 2001 dodge 1500 4x4 the three 6 point bolt heads behind the spindle that hold the bearing in are 15mm 99.9% sure. just ...
bolts that hold the hub and the nut on the center axle.. ill appreciated.. thank you The hub/bearing assembly is mounted to the steering knuckle and is retained by three mounting bolts accessible from
...size to remove the rear. Wheel bearing 2002 Dodge caravan with drum breaks The wheel bearing and hub is a single unit on your Caravan. Four 18mm bolts hold the unit to the rear axle assembly. See the ...
Question about Lincoln Cars & Trucks
...size and grade of the bolt as well as the theard pitch. Nuts usely have higher torque values .For example a nut that holds a CV joint with no bearing involved could be 140 lbs but if a bearing is ...
Question about Cadillac Cars & Trucks
bolts (of unknown size) go from the outside (or tire side) of the car towards the engine. Normally these are hex (15mm) headed and go from the axle side towards the outside. these are what is called a
size the bolts are that hold the seat in. You may have to remove the four nuts holding the seat down, remove the seat, and look for change, or debreas stuck in the track. Check the bearings, lubercate
...size socket for the wheel bearing locknut the axle nut should be a 36mm will also need a 17mm to remove three bolts holding ball joint to control arm and a pry bar to pop axle out of transmission. if ...
395 questions posted
Usually answered in minutes!
1,173 Questions
965 Questions
801 Questions
581 Questions
462 Questions